Call us for free now: 07 3219 6711 service@sa-led.com

SA NSR2-6 SLIM LED NEON FLEX 12V ORANGE (11.52W/M)


Variation NAME PRICE Stock
[ SA6668G-5] 5M ($19.90/M) $ 99.50 35

ITEM CODE : SA 6668G


Enhanced Function
    • High-quality circuit for stable and reliable performance
    • IP67 rate
    • Side bending and small size for easy modeling
    • 12V DC low voltage, safe and reliable
    • 3 x End cap, 3 x Straight hole end cap included.
    • Cutting mark by every 10.4mm.
    • 3 Years Warranty
Clear selection

Share it:
Power Calculator

METRE Indoor Outdoor

 

 

 

Special Note

ROLL LENGTHS_Any claim for short supply will only be considered while
the NEON FLEX is in one length, to prove any manufacturing discrepancy.

*Note that once you cut the roll it will void any claim for short supply of the product.

Troubleshooting Common Faults

Problems Reasons Solutions
No illumination No electricity supply Ensure LED driver is working
Automatic power protection from the open or short circuit in output of the power supply Fix the short circuit problem
Wrong connection of power supply
Partial illumination Using a switching mode power supply Make it as follows: Don’t use switching mode power supplies
Wire connection mistake Check connections
Brightness of LED is inconsistent for inconsistent Power overloaded Replace with a power supply that delivers 125% of current required to power the product
Voltage drop due to exceeding max-in-series limit Adhere to the max-in-series limit specified on the product page
LED Flickering Connection point fault Fix bad connection point
Use a proper LED driver Replace a new power supply

*Note that should be cut and reconnected with end connectors for installation to avoid defects due to moisture penetration. The steps below indicate are possible way of sealing the end:

Installation steps

Cut the neon flex Weld the wire to the PCB board First put silicone glue inside
of the plug, and quick connector
then push into the neon flex
Wipe off the excess glue and
wait for the glue to solidify.

 

[ Important Notice ] How to solder to LED neon flex

 

   Cutting Mark By Every 10.4 mm

Products Features

Note. Soldering Required

Important Note

SA NSR2-6 SLIM LED NEON FLEX 12V ORANGE (11.52W/M)

Installation Precautions

1. All installation and connection must be conducted by qualified electrician.

2. A 12V DC class 2 power supply unit must be used with this LED NEON FLEX.

3. Disconnect the mains power before installing or servicing to avoid electrocution.

4. For a wet location installation you must seal all possible water entry points including covers with clear silicone.

Dimensions(mm)

Weight N/A
Dimensions 8 × 1300 × 12 mm
MODEL

NSR2-6 SLIM LED NEON_ORANGE

POWER

11.52W/M

CURRENT(A)

0.96A

LENGTH

[ SA6668G-5] 5M ($19.90/M)

VOLTAGE

DC 12V

LUMINOUS FLUX

62lm

EFFICIENCY

5.6lm/W

COLOUR

ORANGE

CRI

80

VIEWING ANGLE

139°

DIMMABLE

DIMMABLE

IP RATING

IP67

CUTTABLE

10.4mm

AVAILABLE LENGTH

5M

LED Qty/m

96

WARRANTY

5 YEARS

Reviews


Be the first to review “SA NSR2-6 SLIM LED NEON FLEX 12V ORANGE (11.52W/M)”

*

Navigation

MY CART

Close

No products in the cart.

No products in the cart.

WISHLIST

Close

No products were added to the wishlist